SIN-TDS210-B conductivity meter

Constant	10.00cm-1	1.000cm-1	0.100cm-1	0.010cm-1
Measure range	(0.2-20)	(2.0-2000)	(0.2-200)	(0.02-20.00)
	ms/cm	μs/cm	μs/cm	MΩ·cm
Application	Sewage		Drinking water	Pure water
Measurement Parameters	Measure Rnage		Resolution	Accuracy
Conductivity	0.50μs/cm-20.00ms/cm		0.01μs/cm	1.50%
Resistivity	0.05MΩ·cm-18.25MΩ·cm		0.01MΩ·cm	2.00%
TDS	0.25ppm-10.00ppt		0.01ppm	1.50%
Temperature	(0-50)℃		0.1℃	0.1℃

MeasuringRange	0.01 electrode:0.02 to 20.00us/cm
	0.1 electrode:0.2 to 200.0us/cm
	1.0 electrode：2-2000us/cm
	10.0 electrode:20 to 20000us/cm
Accuracy	±2%FS
Stability	±1%FS/24H
Temperature	Compensation range:-10~130℃.NTC10K
Compensation	PT1000,accuracy:±0.5℃
display	2.8inch LCD display
Relay out	2 ralay out,capacity:250VAC,3A
Signal output	4-20mA output,RS485 communication,compatible
	with standad MODBUS-RTU
Power supply	AC220±10%,50Hz/60Hz
Dimensions	100100150mm(HWD)
Hole Size	92.5*92.5mm

Industry online pH meter controller

Install a 92.5 * 92.5 mounting hole on the instrument cabinet or mounting panel

The instrument into the mounting hole and then buckle on the butterfly, as shown below:

ph controller size

Installation of ph electrode

ph controller install

Schematic diagram of common installation method

①Side wall installation ②Flange mounted at the top ③Pipe installation ④Top installation ⑤Submersible installation ⑥Flow-through installation
The interface must be in 15°oblique angle, or it will affect the normal test and use of the electrode. We won’t be responsible for any results due to this.